Adapting 4-Pole Flat Trailer Connector on 2001 Toyota Tundra to 7-Way Connector on Camper
Updated 08/12/2014 | Published 08/10/2014
Products Featured in This Question
Question:
Please help! Looking for the best way to hook up my camper trailer which has trailer brakes, a power battery bank and reverse lights to my 2001 Toyota Tundra which is equipped with a 4 pole flat pug. I was looking at the adapter 4 Pole to 7 Pole and 4 Pole w/Test Lamps Curt Wiring.
asked by: Irv
Expert Reply:
Since your camper trailer has brakes, you will need to add a brake controller to actuate them. I recommend the Tekonsha Prodigy, part # 90195. To install the controller you will need the # ETBC7 brake controller installation kit. This kit includes everything necessary for installing your controller, including the adapter and circuit breakers.
We have a Brake Controller Installation Guide, as well as some helpful videos that will assist you with the installation.
Product Page this Question was Asked From
TST RV and Marine Super-Concentrated Waste Holding Tank Probe Cleaner - 32 Oz
- RV Black Tank Cleaner
- Black Water Tanks
- Gray Water Tanks
- Tank Cleaners
- Nitrate
- 2 Uses
- Camco
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Seal Recommendation for Dexter 010-004-00
- Q&A: Wiring Diagram For SeeLevel RV Holding Tank Monitor # SE94VR
- Q&A: 2 inch Hitch Adapter to Fit 2-1/2 inch Torklift Magnum Hitch
- Q&A: Recommended Replacement Gas Detector for Old Atwood GS961LP-RV
- Q&A: Will Air Lift Air Bags w/ Air Spring Cradles Require Spacer On 2021 Jeep Gladiator With 2-1/2" Lift
- Q&A: Recommended Trailer Brake Controller for Class 8 Tractor with Air Brakes
- Q&A: Can RV Cabinet Drawer be Removed After Installing RV Drawer Travel Locks 37270765