Should the Timbren System part # TJRC01 Fit Loosely
Updated 08/07/2014 | Published 08/06/2014 >
Question:
The rear susp enhancement Timbrens I just got in from you, fit loosely on my Xterra and have play in them. Im picking up some half inch lock washers to see if this will secure them better. I wanted to know if the play in them, was normal or not?
asked by: Olivia
Expert Reply:
The Timbren System part # TJRC01 that you referenced should not fit tightly. I spoke to my contact at Timbren and he advised me to tell you that you would want to assemble system off of the vehicle on a work bench using vise grips to hold the assembly so that you can get everything torqued down good and tight and then install it on your Nissan Xterra.
Product Page this Question was Asked From
Timbren Suspension Enhancement System - Rear Axle
- Vehicle Suspension
- Towing/Load Leveling
- Bump Stops
- Suspension Only
- Standard Duty
- Rear Axle Suspension Enhancement
- Timbren
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Will EcoHitch Front Hitch Fit with Aux Cooler on a 2024 Ford F-450 Platinum
- Q&A: Difference Between EcoHitch Front Hitches for 2024 Ford F-350
- Q&A: Spare Tire Carrier for Front Mount Hitch on 2008 Ford F-450 Super Duty With 100 lb Tire
- Q&A: Which Timbren Spacer Kit is Needed for a Lifted 2014 Nissan Xterra?
- Q&A: Should I Beef Up the Suspension On a 2006 Nissan Xterra When Towing a Trailer
- Q&A: Timbren or RoadActive Suspension Kit Recommendation for 2012 Nissan Xterra
- Q&A: Replacement Firestone Air Bags for 2015 Nissan Xterra Pro4X

