Looking For Replacement Control Unit For Kwikee Steps 9099507000
Updated 11/06/2026 | Published 11/02/2026 >
Products Featured in This Question
Question:
I havew a step controller for my 2001 country coach Kwikee part 9099507000. I understand this is an older unit, do you sell replacements or know when I can get one?
asked by: Gregory T
Expert Reply:
Hey Gregory, I think you meant Kwikee controller 909507000, which is just one digit different from the number you provided. The Replacement Control Unit # LC59VR is a direct replacement for it if your steps are having issues extending, retracting, or operating consistently, assuming your battery, wiring, and switches are all working properly.
You might also consider spending a little more on the Kwikee Motor Upgrade Kit # LC379145. Rather than replacing just the controller, this kit upgrades the motor, gearbox, linkage, and controller, giving you updated components throughout the operating system.
We'd just need to confirm your Kwikee step series to make sure the upgrade kit is compatible. It fits 22, 23, 28A, 30, 32, 33, 34, 35, 36, 38, and 40 series, but there is another kit for the other handful of series.
Product Page this Question was Asked From
Replacement Control Unit for Lippert Control Module
- Accessories and Parts
- RV Steps
- Control Module
- Lippert
more information >
Continue Researching
- Q&A: Replacement Microwave for my High Pointe EC942K9E in Stainless
- Q&A: Troubleshooting Solera Smart Arm Power Issues
- Q&A: Will the Replacement Water Valve for Thetford Aqua-Magic Style II RV Toilet Work w/ a Thetford 42070
- Q&A: Troubleshooting Kwikee RV Steps Not Working with Switch
- Q&A: Do Solera Replacement Batteries and Awning Switch Wire to Each Other
- Q&A: Recommended Replacement For A Dometic DOTR12CB RV Microwave
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Lippert Control Module for Kwikee Step 1510000140


Gregory T.
11/3/2026
You are correct on the part number—fat fingers! ;-) The LC59VR does not have the same wiring configuration as my current step controller. Specifically, the new controller has a single-pin connector where the old controller has a two-pin connector going to the step motor. Is there a wiring diagram showing how to adapt the existing wiring to the new controller, or is there a conversion kit available to make the two compatible? Thoughts? Thanks again for your help! Greg