Red LED Surface Mount Side Marker Light With Turn Signal Function 4" Wide
Updated 11/08/2026 | Published 11/01/2026 >
Question:
I’m looking for a light three to four inch, rectangle Surface mount LED, red or red lens covered Side marker and turn indicator so three wires Anyone there have a suggestion for me? I can find just marker lights all day long, I’d really like the added turn indicator for a little more protection.
asked by: Hughie M
Expert Reply:
Hey Hughie!
I found exactly what you're describing with the Optronics LED Trailer Light # OPT44NR. It's a 4" x 2" rectangular light with a red lens, mounts directly to the trailer's surface, and has three wires for running lights, turn signals, and ground.
It even has a built-in reflector, so it'll work nicely as an additional side marker and turn indicator for better visibility.
What kind of trailer is this going on?

Sherman
11/3/2026
I think that I remember that these are red LEDs. I am away from my trailer for a couple days but I will try to remember when I am back.

Sherman
11/5/2026
I just pulled out a spare OPT44NR that I have and tested it on the bench and the LEDs are definitely red.


Jeffrey
11/7/2026
These lights were just what I needed, turning my clearance lights on the back of my r v into turn signals works great.

Product Page this Question was Asked From
LED Trailer Light w/ Reflex Reflector - Clearance, Turn Signal, or Side Marker - Rectangular - Red
- Trailer Lights
- Clearance Lights
- Marker
- Turn
- Rectangle
- Surface Mount
- Non-Submersible Lights
- LED Light
- 4L x 2W Inch
- Red
- Optronics
more information >
Continue Researching
- Q&A: Looking for Replacement Hinge Plate for MORryde Step Setup on 2021 Venture Sonic Lite SL16 VUD
- Q&A: Correct Way to Wire Trailer Breakaway Kit
- Q&A: Getting Side Marker Lights to Function as Turn Signals and Running Lights
- Q&A: Troubleshooting a Bouncing Boat Trailer, Possible Causes and Solutions
- Q&A: Wheel Chock Recommendation for Harley in Trailer
- Q&A: Recommended Torque for Tightening Curt Hitch Balls to Ball Mount
- Q&A: How to Torque Hitch Ball When Installing into Ball Mount
- Article: Trailer Wiring Diagrams
- Article: Trailer Tire Sizing
- Article: Trailer Lighting Requirements
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision



Hughie M.
11/3/2026
I have a Texas Pride hotshot flatbed with their Mega Ramps. I can’t see the little quarter sized light that the put on Throne end of the trailer while I am driving. So I am looking for something to install on the flip over ramps. The ramps are inset just a little on each side from the actual exterior of the trailer so I will have to 3D print some offsetting brackets to extend them out just a tad, but that is well within my level of expertise. I’ll give these a look after work today. Thanks.