Adding Roadmaster Comfort Ride to Triple Axle Toy Hauler With 2-1/4 Inch Hangers
Updated 09/04/2026 | Published 08/22/2026
Products Featured in This Question
Question:
Hey etrailer, I'm looking at adding the Roadmaster Comfort Ride to my triple axle toy hauler. I measured my hangers and they're only 2-1/4" from the frame to the center of the bolt. It looks like the Comfort Ride needs 3-1/4" hangers. Will these spacers let me install it? I believe I have either 7K or 8K axles but I'm not sure.
asked by: Derek L
Expert Reply:
Hey Derek! Yes, the Roadmaster Comfort Ride Spacer Block Kit # RM97MW is exactly what you need with your 2-1/4" hangers. The spacers install on the front and rear axles to compensate for the shorter hangers so you can install the triple axle system. For the Comfort Ride itself, you will need one of the following based on your axle capacity and diameter:
-Roadmaster Comfort Ride for Triple 7K Axles - 3" Diameter # RM-2460-2570-3
-Roadmaster Comfort Ride for Triple 8K Axles - 3" Diameter # RM-2460-2580-3
-Roadmaster Comfort Ride for Triple 8K Axles - 3-1/2" Diameter # RM-2470-2580-3
If you can send me the axle tag information, or the axle diameter, I can help you identify which kit you need if you aren't sure.
Where are you headed next with your toy hauler once you get the Comfort Ride installed?
(click to enlarge)
Product Page this Question was Asked From
Roadmaster Comfort Ride Leaf Spring Suspension Kit w/ Shock Absorbers - Triple 7K Trailer Axles
- Trailer Suspension Parts
- Equalizer Upgrade Kit
- Leaf Spring Replacement System
- Suspension Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- 7000 lbs
- Round Axle - 3 Inch
- Triple Axle
- Roadmaster
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Replacement Leaf Spring for a Dexter 072-079-01 Leaf Spring
- Q&A: Replacement 6-Leaf, 7,000LB Double Eye Spring For a 2012 Dutchman Voltage 3950 Toy Hauler
- Q&A: Can I Use Heavier Rated Leaf Springs on Trailer Without Causing Damage
- Q&A: Recommendation for Adding Third Axle To Trailer Suspension
- Article: Double-Eye Trailer Suspension System Review
- Q&A: What is the Difference Between the MORryde CRE3000 and AllTrek 4000 Suspension Kits
- Q&A: Solution for Needing Replacement Dexter Axle with Number 7658660 Part Number
- Q&A: Do Trailer Hub Seals Get Damaged When Pulling Hub Off to Inspect Brake Assemblies
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: RV AC Not Cooling? What's Normal, What to Check, and When to Replace
- Article: Glacier Chains
- Article: Trailer Wiring Diagrams
- Article: Slipper Spring Trailer Suspension System Review
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs