What are the Dimensions of the Enclosed Trailer Door Hook and Keeper # 383400
Updated 07/23/2014 | Published 07/22/2014
Question:
Can you give me the physical dimensions of the two pieces for this part? Especially the distance between bolt holes.
asked by: Randy W
Expert Reply:
I went out to the warehouse and pulled Enclosed Trailer Door Hook and Keeper # 383400 to measure it. First, the mounting holes are 2-5/16 inches across on center and 1 inch top to bottom on center.
The mounting plates for both pieces are 3 inches by 1-3/4 inches.
From the center of the hook piece to the end of the hook is 4 inches.
The hook piece sticks up 1/2 inch from the mounting surface. The keeper piece sticks up 3/4 inches from the mounting surface.
I have also included a picutre showing the measurements for you.
Product Page this Question was Asked From
T-Style Hook and Keeper Door Holder for Trailer Rear or Side Door - 4" Hook - Zinc Plated
- Trailer Door Holders
- Hook and Keeper
- Straight
- 4 Inch Long
- 2-5/16 x 1 Inch Hole Spacing
- Steel
- Polar Hardware
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Recommended Door Holder to Hold a Trailer Door at a 45° Angle
- Q&A: What Size Hole Do I Drill In Bed For B&W Gooseneck Turnover Ball In 2026 GMC Sierra 2500 ?
- Q&A: Availability of Victron DC/DC Battery Charger With Lithium Compatibility and Engine On Detection
- Q&A: Spare Tire Cover Needed for a 205/75-15 Size Tire
- Q&A: Greasing Trailer Axle Spindle Where Zerk Fitting Broke Off
- Q&A: Recommended Replacement Manual Override Rubber Plug for a 2021 K-Z Sportsmen Travel Trailer
- Q&A: What Size Hole Saw do I Need to Make the Hole in the Bed of My Truck to Install B&W Gooseneck Hitch?
- Article: What is Boondocking
- Article: Converting Your RV Water Heater to Tankless
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Trailer Maintenance Schedule
- Article: How Much Solar Power Do I Need For My RV?