What are Bolt Hole Dimensions of CE Smith Front/Rear Hanger Bracket for Double-Eye Springs # CE14026
Published 05/27/2026
Question:
No dimensions for the bolt pattern to the trailer, which for me must be 4 1/2 x 2 1/2“ to replace a corroded bracket
asked by: B
Expert Reply:
Hey Bill,
The bolt hole spacing for the CE Smith Front/Rear Hanger Bracket for Double-Eye Springs # CE14026G is 4-3/8" x 1-5/8". Hopefully that would be close enough to work for you.
I've attached a dimensional photo for you to check out as well.
(click to enlarge)
Expert Reply:
Hey Bill,
The bolt hole spacing for the CE Smith Front/Rear Hanger Bracket for Double-Eye Springs # CE14026G is 4-3/8" x 1-5/8". Hopefully that would be close enough to work for you.
I've attached a dimensional photo for you to check out as well.
Product Page this Question was Asked From
CE Smith Front/Rear Hanger Bracket for Double-Eye Springs - Galvanized Steel - Bolt On
- Accessories and Parts
- Trailer Suspension Parts
- Brackets
- CE Smith
more information >
Continue Researching
- Q&A: Internal Dimensions for Suspension Hangers
- Q&A: Replacement Trailer Springs and Shackle Straps for EZ Loader Boat Trailer
- Q&A: New Hangers for my Trailer
- Q&A: Bolt Hole Dimensions for CE Smith Front/Rear Hanger Bracket for Double-Eye Springs
- Q&A: Replacements For Hadco Trailer Axle With Hadco 3109 Hubs
- Q&A: Difference Between 3-Leaf and 4-Leaf Leaf Springs
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Q&A: Can I Use Heavier Rated Leaf Springs on Trailer Without Causing Damage
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: Slipper Spring Trailer Suspension System Review
- Article: How to Accurately Measure Trailer Leaf Springs