How Do I Measure to Find out what Bearing Buddy I Need
Published 01/20/2010 >
Question:
How do I measure to make sure I order correct diameter bearing buddy?
asked by: Kim
0
Expert Reply:
Measure the diameter of the pilot hole of your hub. Bearing Buddies replace the grease cap on the hub. Remove the wheel and tire and pop off the grease cap from the center of the hub. Usually it is a metal cap that is just lightly hammered into place. Use a screwdriver to pry off the cap. Clean the grease off and measure the opening. I have included a video demonstrating the Bearing Buddy.
expert reply by:
Patrick B
0
Product Page this Question was Asked From
Bearing Buddy Bearing Protectors - Model 1810 - Chrome Plated - Qty 2
- Trailer Bearings Races Seals Caps
- Caps
- Bearing Protector Grease Cap
- 1.81 Inch
- 3500 lbs Axle
- Bearing Buddy
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Actuator for an Older Atwood 85736
- Q&A: Need a Grease Seal With Inner Diameter of 1.845 Inches and Outer Diameter of 2.442 Inches
- Q&A: Which Bearing Buddy Would Fit in Hub Bore that is 1-7/8 inches
- Q&A: Ribbed Rubber Mats for Floor of Horse Trailer
- Q&A: Rubber Mat Needed for a 7 foot x 20 foot Gooseneck Featherlite Stock Trailer
- Q&A: What Direction Should the Caliper Mounting Bracket Face on Kodiak Disc Brake Assembly, # K1HR35D
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Bearing Buddy Available for Hub Bore that Measures 1-7/8 inches
- Article: How to Measure for Trailer Hitch Drop
- Article: Most Popular Wheel Bearings
- Article: How to Bleed Your Trailer Surge Brakes
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: How to Measure a Trailer Axle
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub


