Clearance Dimensions of Rail Kit for Kwikee RV Cargo Slide Tray Assembly # LC370793
Updated 02/25/2026 | Published 02/23/2026 >
Question:
part LC370793 - two questions. 1. What is the clearance between the 4inch angle iron horizontal support leg and the horizontal leg of the angle iron of the sliding tray? i.e. what max length bolt can be installed when mounting a cargo tray platform to the sliding tray w/o the bolt hitting the 4inch angle iron support? 2. What is the width of the rail assembly from the outside edge of the vertical leg of the 4inch mounting angle iron to the inside edge of the vertical leg of the sliding angle iron? Tim O.
asked by: Tim O
Expert Reply:
Hey Tim, the answer to your first question about the part # LC370793 is right at 3/4 inches from the top of the mounting bracket to the bottom of the L that slides on the track. The answer to your second question is right at 1/8 of an inch.
Product Page this Question was Asked From
Rail Kit for Kwikee RV Cargo Slide Tray Assembly - 22" Long - 200 lbs
- RV Cargo Slides
- Cargo
- No Floor
- Adjustable
- 1 Way
- 22 Inch Long
- 200 lbs
- Kwikee
more information >
Continue Researching
- Q&A: Best Slide-Out Tray Options for Camper Van Storage 32" Deep x 48" Wide
- Q&A: Generator Slide Out Tray For a Preator 3,500 Watt Generator
- Q&A: Curt TriFlex NEXT Brake Controller and Install Harness for 2022 E-Series Cutaway
- Q&A: Compatibility Of The Rear View Safety Color Monitor And Factory Camera Wiring
- Q&A: Best Way to Level a Class A Motorhome at a Curb
- Q&A: Recommended 200% Extension Sliding Cargo Trays For An RV Outdoor Kitchen
- Q&A: Will Furrion Chill Cube Work On Sloped Roof
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Trailer Wiring Diagrams
- Article: Where to Position the Trailer Axle?
- Article: Using a Portable Generator on RV
- Article: Which RV Propane Tank Size Do I Need?
- Article: Performance Chips and Modules
- Article: How to Measure Your Trailer Wheel Bolt Pattern

