Dimensions Of Receiver Tube On Draw-Tite Max-Frame Trailer Hitch Receiver DR64FR
Updated 01/27/2026 | Published 01/13/2026
Question:
What is the total length of the 2inch tube? Specifically the pin hole to the rear of the ? Is it straight through with nothing to stop an ? I have a swing away tire carrier made by Rigd Supply that wont go in my current hitch to be able to put a hitch pin in. The attached photo shows a curt hitch carrier with a stop on the upper part of the rear .
asked by: Jon Y
(click to enlarge)
Expert Reply:
Hello Jon, thanks for reaching out. I took a walk out to our warehouse and measured the Draw-Tite Max-Frame Trailer Hitch Receiver # DR64FR. The total length of the 2" receiver tube is 6-1/4". From the center of the hitch pin hole to the rear of the tube is approximately 4-1/8". The tube is completely open on the back there are no obstructions or stoppers or anything, so it sounds like this'll work with your swing away carrier.
The # DR64FR hitch will fit a 2020-current Jeep Gladiator, excluding the Rubicon model.
Hope this helps! Let me know if there is anything else you need.
Continue Researching
- Q&A: Front Hitch For 2022 Jeep Wrangler Unlimited Rubicon Edition
- Q&A: Can Curt Front Hitch C31086 Work With Steel Skid Plate On 2022 Jeep Gladiator Latitude
- Q&A: Recommended Front Hitch Receiver for 2018 Jeep Wrangler Unlimited Rubicon JL
- Q&A: Does Curt Front Hitch C31086 Fit 2021 Jeep Wrangler Rubicon
- Q&A: Does the Curt C31086 Front Hitch Fit a 2023 Jeep Wrangler Rubicon?
- Q&A: Can Metal Skid Shield/Air Dam be Made to Fit with Front Hitch on a 2018 Jeep Wrangler Rubicon
- Q&A: Does Curt Front Hitch # C31086 Fit 2018 Jeep Wrangler JL Rubicon with Winch
Jesse M.
1/27/2026
Hey Jon, how did the Draw-Tite hitch work out with your Rigd swing-away carrier? It sounds like the open tube design should have solved the fit issue. Your update could make it easier for others trying a similar setup.