Inexpensive Coupler For A 3" Channel On A Small Wood Chipper
Updated 01/19/2026 | Published 12/29/2025 >
Products Featured in This Question
Question:
Inexpensive 2 5/16 bolt on coupler to fit 3 channel mount. Using on small wood chipper.
asked by: Ross J
Expert Reply:
Hi Ross!
Do you know the bolt hole spread on your channel? Both of the below options have a 2" on center bolt pattern and is the typical measurement, but let me know if your spacing is different.
Pro Series Adjustable-Channel Coupler w/ Low Latch - 2-5/16" Ball - 14,000 lbs # PSA256S0303
Demco Trailer Coupler - Cast - Adjustable Channel - eZ-Latch - Black - 2-5/16" Ball - 21K # DM14040-81
The Demco coupler is a little more expensive than the Pro Series coupler, but I very much prefer their eZ-Latch system. It is by far the easiest to live with currently on the market. At least in my opinion.
Product Page this Question was Asked From
ThinLine LED Clearance or Side Marker Light - Submersible - 2 Diodes - Rectangle - Red Lens
- Trailer Lights
- Clearance Lights
- Marker
- Rectangle
- Surface Mount
- LED Light
- Red
- Optronics
more information >
Continue Researching
- Q&A: Recommended Valve Stem For 125-130 PSI And TPMS Sensors
- Article: Trailer Wiring Diagrams
- Q&A: How is Horse Trailer Side Pad # HTP60BK Usually Attached
- Q&A: Length of Universal Diamondstep Rear Bumpers
- Q&A: Replacement Trailer Clearance Light for a Haulmark Trailer
- Q&A: Replacement Locking Door Latch for a Eberhard Door Latch
- Q&A: Spare Tire and Wheel for Homesteader Patriot Trailer with Tire Size 205/75-15
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Lighting Requirements
- Q&A: 16 x 6 Dually Wheels with 4.88 Pilot Hole and 8 on 6-1/2 Bolt Pattern
- Article: Cleaning Your RV Black Water Tank in 4 Easy Steps
- Article: How To Measure And Replace Everything In Your Hub Assembly
- Article: How to Install E-Track in 3 Easy Steps
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers




Lazer S.
1/19/2026
Hey Ross, did you get a chance to check the bolt hole spacing on your channel mount for the wood chipper? Once you know that measurement, I can help confirm which coupler will fit best. Let me know what you find—I’m here if you need a hand narrowing it down.