Will the MORryde Sliding Tray MR83MV Fit a 2015 Toyota 4Runner Limited?
Updated 12/29/2025 | Published 12/09/2025
Products Featured in This Question
Question:
Will this fit a 2015 Toyota 4Runner Limited?
asked by: Jay H
Expert Reply:
Hey Jay. The MORryde Sliding Tray item # MR83MV should fit in the rear cargo area of your 2015 Toyota 4Runner Limited but it's not designed for it so you'll want to take a couple of measurements to confirm. The slide measures 31-1/2" wide x 26-1/2" deep and the mounting brackets extend a couple of inches past the tray on either side.
How wide is the space between the wheel wells and how deep is that area from the door to the rear seats on your 4Runner?
You can add this information, along with any other questions you have, where it says Reply to Jerred H.
(click to enlarge)
Product Page this Question was Asked From
MORryde Cargo Area Sliding Tray for INEOS Grenadier - 250 lbs
- Car Organizer
- Rear Cargo Area
- Cargo Slide
- Bolt-On
- Black
- MORryde
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: What are the Interior Dimensions of the Yakima MOD HomeBase SUV Storage Drawer
- Q&A: Tray Clearance For The MORryde Refrigerator Tray # MR59RR
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Q&A: Recommended Tire Chains for 285/70-17 Tires on Toyota 4Runner
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Kit for Installing Demco Air Force One in Chevy Colorado Where RV has Air Force One Components
- Q&A: Does The Negative Battery Cable On a Chevrolet Colorado Need To Be Disconnect While In Tow
- Q&A: SoftStart for Furrion Chill RV AC Unit 13.5k BTU Unit
- Q&A: Does Negative or Positive Battery Post Get Disconnected for Roadmaster Battery Disconnect
Jerred H.
12/29/2025
Hey Jay, did you get a chance to measure the cargo space in your 4Runner for the MORryde sliding tray? Once you had those numbers, did the fit look workable? Your update could make it easier for others checking the same setup.