Can M3 Enclosed Trailer Transition Plate Be Trimmed To Fit 6-1/2 Foot Wide Ramp Door?
Published 11/19/2025
Products Featured in This Question
Question:
Can I cut this to fit my 6-1/2 foot ramp door, or will that mess up the hinge?
asked by: Chris
0
Expert Reply:
Good question, Chris - yes, both M-3 plates are designed so you can cut them down. Just trim from the outer edge and if you’re using the steel # M368FR, touch up the cut edge with paint to keep it sealed. The aluminum # M348FR doesn’t need that since it won’t rust.
Do you already know your door width?
expert reply by:
Andrew N
0
Product Page this Question was Asked From
Enclosed Trailer Transition Plate - 81-3/4" Long - Steel - Qty 1
- Trailer Door Parts
- Transition Plates
- Bolt-On
- 81 Inch Wide
- Steel
- M-3 and Associates
more information >
Continue Researching
- Q&A: Recommended Ramp Door Transition Plate That Can Handle a Pallet Jack
- Q&A: What Sealant Should I Use Between an Aluminum Jeep-Style Fender and My Trailer?
- Q&A: What is the Difference Between etrailer Enclosed Trailer Transition Plate # e32JR & # e99RV?
- Q&A: Will Aluminum Transition Plate Bend On Enclosed Trailer When Loading Heavy Zero Turn Mower?
- Q&A: Steel Transition Plate For Rolling Pallet Jack Over Gap On Trailer Door Ramp
- Q&A: Steel VS Aluminum Transition Plate For 7x12 Enclosed Trailer
- Q&A: Can M3 Trailer Ramp Transition Plate Be Used For Inside Gap Between Ramp And Trailer Floor?
- Article: How to Install E-Track in 3 Easy Steps
- Article: How to Install an RV Awning From Scratch
- Article: What Do I Need To Tow A Trailer?
- Article: Gooseneck to 5th Wheel Adapters
- Article: Best RV Roof Vents
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: How to Measure for Trailer Hitch Drop