Can I Use the Same Magnetic Heater Pad For Tractor And Generator Motor Oil?
Updated 11/13/2025 | Published 11/05/2025
Question:
Can I move the Heat Magnet from my tractor to my generator without damaging it?
asked by: Doris
0
Expert Reply:
You sure can, Doris - that’s one of the big perks of the Zerostart Heat Magnet # ZE35MR. It’s fully reusable/moveable: just unplug, lift it by the handle, and place it on the next metal surface and plug it back in. The built-in thermostat protects it even during extended use, so you can swap between machines as needed and just leave plugged in.
Are both units steel-pan engines? That’ll confirm you’ll get full magnetic hold on each.
expert reply by:
Andrew N
0
Product Page this Question was Asked From
Zerostart Heat Magnet Heater - 2-1/2" Long x 4-3/8" Wide - 120V - 200 Watts
- Oil Pan Heater
- Magnetic Heater
- 120 Volts
- 200 Watts
- 2-1/2L x 4-3/8W Inch
- Zerostart
more information >
Continue Researching
- Article: Electric Trailer Brakes: How They Work & What to Buy
- Q&A: Will A 125W Heat Pad Be Enough For 6 Quart Oil Pan On Pickup In The Winter?
- Q&A: Can Kats Magnetic Heater Be Left On Overnight
- Q&A: What Is The Correct Oil To Use In My Dexter Axles With Oil Lube Bath Hubs?
- Q&A: How to Test the Kats Heaters Custom Fit Engine Block Heaters Before Installation
- Q&A: Is it Okay to Use SumoSprings Solo Custom Helper Springs on a 2018 Chevy Suburban?
- Q&A: Will ThermaHeat RV Holding Tank or Step Heater Pad Help With Cold Weather Camping
- Q&A: Front Suspension Enhancement For A 2022 GMC Yukon
Doris
11/13/2025
Thanks, Andrew. Both my tractor and generator have steel pans. Can I leave it plugged in on the generator all night or should I only run it a few hours before starting?