What is Overall Width of Shocker Pintle Hook Attachment # SHK79ZR
Updated 11/05/2025 | Published 10/31/2025
Question:
how wide is the base where you put the pins through? I need one that is 3-1/8
asked by: Tim
0
Pintle Attachment
(click to enlarge)
(click to enlarge)
Expert Reply:
Hey Tim, the Shocker Pintle Hook Attachment # SHK79ZR that you referenced is designed to fit into a channel that is 3-3/4 inches wide. That means the overall width of this would be too wide. Do you have a channel already that is designed for mounts that are 3-1/8 inches wide? If so, what brand is it?
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Shocker Pintle Hook Attachment for Shocker Bumper Hitches - 3" Drop - 20K
- Accessories and Parts
- Drop Hitch
- Trailer Hitch Ball Mount
- Shocker Hitch
- Pintle Hook Attachment
- Shocker Hitch
more information >
Continue Researching
- Q&A: Recommended Tire Linc Pro TPMS for RVs and Trailers
- Q&A: Repair Kit for 12000-lb-Rated Bulldog Square Tube Jack
- Q&A: Replacement Screw and Nut for Bulldog 10K / 12K Square Trailer Jack
- Q&A: Replacement Cap for 4 inch Square Trailer Jack
- Q&A: Troubleshooting Overheating Hubs on a Trailer With New Bearings and Grease
- Q&A: Potential Causes for Trailer Hub to Heat Up
- Q&A: Replacement Fan Motor For An Everchill Refrigerator
- Article: Most Popular Wheel Bearings
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
Tim
11/5/2025
Yes, I have one it is a Koerdo.