What is Width of Mounting Bracket of EZ Connector Magnetic 7-Way Trailer Connectors
Updated 10/30/2025 | Published 10/04/2025 >
Question:
What is the width of the mounting bracket for the vehicle side plug? Im thinking this would be a great plug for my motorcycle trike and the trailer I pull. Im thinking about mounting on the top of the receiver neck.
asked by: Jerry O
0
Expert Reply:
Hey Jerry, the width of the mounting bracket of the EZ Connector Magnetic 7-Way Trailer Connectors w/ Watertight Seal # 319-R7-01 that you referenced is 4 inches. Would that be small enough to work?
expert reply by:
Jameson C
0
Product Page this Question was Asked From
EZ Connector Magnetic 7-Way Trailer Connectors w/ Watertight Seal - Hardwire - Vehicle/Trailer End
- Trailer Wiring
- Trailer Connectors
- Trailer and Vehicle End Connector
- 7 Contact
- Plug and Lead
- EZ Connector
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Trailer Hitch for 2026 Toyota RAV4
- Q&A: Does Curt Hitch C37RV Fit 2026 Kia Sorento PHEV Hybrid
- Q&A: Kodiak 225 Stainless Calipers Assembly Rebuild Kit KDBC250KIT
- Article: Trailer Wiring Diagrams
- Q&A: Recommended Stabilizer Jack for a Aluminum Trailer w/ Low Ground Clearance
- Q&A: How to Mount 7-Way Connector on a 2015 Land Rover Range Rover Sport with 2" Trailer Hitch
- Q&A: Does the B&W Turnoverball Gooseneck Hitch interfere with Removing the Rear Shock on Ford F-250/350?
- Q&A: Looking For Good Quality 7-Way Trailer Side Pigtail
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: The Best Electric Trailer Jacks of 2025
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
- Article: How to Winterize & De-Winterize Your RV (Simple Guide)
- Article: How to Wire an Electric Winch
- Article: My Trailer Hitch Doesn't Fit



Jameson C.
10/30/2025
Hey Jerry, did the 4-inch bracket width end up fitting well on the receiver neck of your trike? Your update could make it easier for others setting up a similar trailer connection.