What Kind of Oil Should Be Used w/ a Dexter Dual Hydraulic Jack System?
Updated 09/12/2025 | Published 08/16/2025 >
Question:
What kind of oil do you use in them?
asked by: Teresa B
0
Expert Reply:
Hey Teresa. I checked with Dexter and for their Dual Hydraulic Jack System w/ Double Acting Pump item # DX42CR they recommend using Dexron III ATF.
Depending on what climate you are operating in you may need to use a synthetic hydraulic fluid rated for aircrafts. MIL-H-83283 is recommended for use in extreme cold environments.
What kind of trailer do you have?
expert reply by:
Jerred H
0
Product Page this Question was Asked From
Dexter Double-Acting Hydraulic Tandem Jack System - 20" Lift - 20,000 lbs - Direct Weld
- Trailer Jack
- Dump Trailer
- Enclosed Trailer
- 5th Wheel Trailer
- Gooseneck Trailer
- Side-Mount Jacks
- 10001 lbs or More
- Hydraulic Jack
- Weld-On
- With Rectangle Foot
- Dexter
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Installation Time for Blue Ox BX1128 Flat Tow Base Plate Kit for 2016 Jeep Grand Cherokee
- Q&A: Replacement Front Mounted Trailer Jack For Cattle Trailer
- Q&A: Dual Electric Jacks for 24,000 lb Gooseneck Trailer
- Q&A: Ultra Fab Electric Landing Gear Replacement for 2006 Keystone Raptor 3319
- Q&A: Comparing the Reese # RP500708 and Ultra-Fab Deluxe # UF17-943010 Landing Gear
- Q&A: Which Caliper Should Be Used With The Dexter 9-3/4" Hub-and-Rotor Assembly DX82UR?
- Q&A: Will Dometic FanTastic Roof Vent Assembly Upgrade Kit Fit Older Fan-Tastic Vent
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Trailer Lighting Requirements
- Article: Converting Your RV Water Heater to Tankless
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: It's Fun Until It Breaks: Synthetic or Steel Winch Rope
- Article: Trailer Wiring Diagrams



Jerred H.
9/12/2025
Hey Teresa, did you find the right oil for your trailer's hydraulic jack system? If you're still looking for a solution, I'm happy to help.