How Is The GE Profile Propane RV Range GE37VR Powered?

Question

Question:

My 2024 Solitude has an Insignia range and parts are impossible to find for it. I am looking at the GE Profile GE37VR as a replacement but I will need a 120VAC to 12VDC converter. Do you have a unit I can plug into 120VAC and wire the output directly to the stove?

asked by: Tim E

0

Expert Reply:

Hello Tim, thanks for reaching out. I am not quite sure what you are looking for here. The GE Profile Propane RV Range # GE37VR runs off 12VDC power. The power supply connection on the back of the oven is wired to a 12v power supply. Assuming your camper is equipped with a converter and power center, that would be sufficient to get power to the oven. You would not need to convert 120v to 12v since your RV converter would already be providing 12vdc.

expert reply by: Jesse M

0

Tim E.

8/13/2025

Jesse, My Solitude has an AC outlet behind the Insignia range and the range plugs into that outlet. Since the GE Profile range uses DC voltage, I thought I could use a 12VDC power supply that plugged into that outlet behind the stove. After watching Andy’s video on the GE Profile range, how did he get electric to the stove? Regards Tim

Jesse M.

8/14/2025

@TimE I talked to Andy and in that video he had the range hooked up to a 12v power box using alligator clips. The 12 power box just plugs into a wall outlet. We do not offer any kind of adapter for this so if you plan to use a 12v range you would need to wire it directly to 12v power per the instructions.

Answer 1

Hey Bobby, thanks for reaching out! The Greystone Freestanding Propane RV Range #GR26GR is designed to connect to your propane gas line on your RV as opposed to a standalone propane tank. If your RV has standard 20 lb or 30 lb tanks then you'll…

view full answer...

Answer 2

Yes, it will Dj. The interior dimensions of the GE Profile Propane RV Range item #GE37VR are 18-15/16" wide x 17-31/64" tall x 17-31/64" deep. So long as your pan has external dimensions of 18" x 13" it's going to just…

view full answer...

Answer 3

Hey John, yes you could use a 120 volt to 12 volt converter to allow you to use the GE Profile Propane RV Range part #GE37VR with a 12 volt power source. Do you have a converter already?

view full answer...

Answer 4

I suggest pulling the 12 volt DC fuse and let it sit for 15-20 minutes to try and hard reset the 4900N MaxxFan Deluxe Roof Vent. You should check all the wires and connections for damage like corrosion, shorts or overheating. If this doesn't work…

view full answer...

Answer 5

Hey Ryan! Yes, the Dexter E-Z Flex Suspension Kit #K71-653-00 is what you need for your Grand Design Imagine. The length of this equalizer matches the Dexter 13-122 that came with your trailer, which is the most important factor so you keep the…

view full answer...

Answer 6

The Atwood 87701-SP three-switch panel that you referred to is now obsolete, no longer made, and none in stock. The only wiring information I could find for you is a poor quality drawing from Atwood/Lippert which I have attached. We do not have this…

view full answer...

Answer 7

For your 2004 Winnebago Rialta motorhome I recommend going with the LED Clearance or Side Marker Trailer Light w/ Reflector #MCL0030ABB. This light is only 3/8" thick and uses an LED so there is no need to change the bulbs when they go out. It…

view full answer...

Answer 8

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

How Is The GE Profile Propane RV Range GE37VR Powered?

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching