What Wheels Will The Bumper Spare Tire Mount TR-1 Work With?

Question

Question:

Spare tire bumper mount won’t work with a carry all

asked by: Terry L

0

Expert Reply:

Hello Terry, thanks for reaching out. The Bumper Spare Tire Mount # TR-1 will work with most 15" and 16" trailer tires with a standard 5-lug, 6-lug or 8-lug bolt pattern. What kind of wheel are you trying to use it with?

expert reply by: Jesse M

0

Jesse M.

8/15/2025

Hey Terry, did you find the right wheel to use with the Bumper Spare Tire Mount? I'm curious because it could help others who might have the same setup.

Answer 1

Yes the Brophy Rigid Mount Spare Tire Carrier #BR56VR that you referenced would fit your bumper that is 4 inch square, has enough weight capacity, and can work with your bolt pattern.

view full answer...

Answer 2

The Bumper Mounted Tire Carrier - U-Bolt Mount #TR-1 is only for tires without the deep offset. There isn't a bumper mounted option spare carrier, but the Lippert Components RV Spare Tire Carrier with Winch - 71" Overall Width #LC159041, the…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 5

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 6

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 7

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 8

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 9

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

What Wheels Will The Bumper Spare Tire Mount TR-1 Work With?

Product Page this Question was Asked From

Continue Researching