Will Classic Accessories 17 to 19 Foot Long V-Hull Boat Cover Fit a 2002 Monark King 190
Updated 06/18/2014 | Published 06/17/2014
Products Featured in This Question
Question:
I have a 2002 Monark King 190. Its 19ft. 6 inches with a 93 inch beam. I have cover support bows installed. The description says for 17 to 19 ft. Im concerned it might be short in length and width.
asked by: Steve
Expert Reply:
Like you said, the Classic Accessories cover # CA20086 fits 17 to 19 foot long V-hull boats. It also fits beams up to 102 inches wide. It does not seem like width would be an issue. Provided the cover supports you have do not reach up higher than the wind screen, if applicable, then I do not foresee there being a problem.
You could step up to the next highest size, # CA20087, which fits 20 to 22 inch long V-hull boats and beams up to 106 inches. But if it is too large it would not fit properly unless the slack was somehow eliminated.
Product Page this Question was Asked From
Classic Accessories DryGuard Waterproof Boat Cover - 17' to 19' Long - Up to 102" Beam
- Boat Covers
- V-Hull Boat Cover
- Vented
- 102 Inch Beam Width
- 17 Foot Boats
- 18 Foot Boats
- 19 Foot Boats
- Tan
- Classic Accessories
more information >
Continue Researching
- Q&A: Comparing Classic Accessories Boat Covers for 2015 Crestliner Raptor
- Q&A: Difference Between Classic Accessories Boat Covers 052963889383 and CA20085
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: Can Fulton XLT Powered Drive Trailer Jack Be Powered by Truck's 7-Way Connector
- Article: How to Measure a Trailer Axle
- Q&A: Recommended Storage Cover for a 11.5' Boston Whaler Sport
- Q&A: Difference Between a ST175/80D13 and a ST175/80R13 Trailer Tire
- Q&A: How To Determine Fit of the 3,200 Lb 2-Speed Boat Trailer Winch
- Q&A: Recommendation For Greasing Boat Trailer Bearings - Regular or Marine Grease