Where to Hook Front Strap for Kayak Carrier
Updated 07/09/2025 | Published 07/03/2025
Question:
Looking for a way to secure bow tie down on 2025 Kia EV6 AWD long light. No room under the bonnet for tube and tie, no ridges for Yakima hood anchor to grab. I have an inquiry to service dept re Thule bolt on. The best 2 spots look like they are connected to something I shouldnt mess with! Any ideas?
asked by: Barbara S
0
Expert Reply:
We haven't had specific experience with that vehicle but if you were to go over the front of the vehicle and then back under the front bumper is there maybe something there that could be hooked onto? Maybe even just the edge of the bumper?
expert reply by:
Jameson C
0
Product Page this Question was Asked From
SportRack Bow/Stern Tie-Down Straps - Qty 1
- Accessories and Parts
- Watersport Carriers
- Bow and Stern Straps
- SportRack
more information >
Continue Researching
- Article: Roof-Mounted Watersport Carriers
- Q&A: Replacement Parts for Karrite Roof Mounted Cargo Box
- Q&A: Roof Mount Kayak Carriers that Can Hold Up to 4 Kayaks
- Q&A: Thule TH480R Rapid Traverse Roof Rack Feet Compatibility With Old Type Square Crossbars
- Q&A: What is the Difference Between the Thule Traverse 480 and Rapid Travers 480R?
- Q&A: Maximum Tire Width Recommendation For The Thule RV Wheel Levelers # TH307617
Barbara S.
7/9/2025
I figured out a way! I ran the bow line through the bracket in the center where the bonnet latch grabs hold when closed. Made a loop about 12" long using a bowline knot. Slid line to the very top/back so the latch wouldn't touch the line when the bonnet was closed and when line was under tension. This will only work with a thin rope style line. A strap would be too bulky.