Replacement Latch for 2005 Sundowner Dressing Room
Updated 09/29/2025 | Published 05/15/2025
Question:
Paddle door on our 2005 Sundowner dressing room broke. Needs replacing. Pkease recommend part and how to remove/ open locked paddle lock
asked by: Simone M
Expert Reply:
Hi Simone; can you send me the dimensions of your cutout? I will need this once you get the latch open and removed to find a good fit. For example, a door lock like # BA54FR fits cutouts that are 2-3/4" wide x 3-3/4" tall and doors that are 1-1/4" to 1-1/2" thick. As far as removing/opening it is concerned, it really depends on what exactly is broken. If it is the lock itself you can expect to have to drill it out. You should be able to remove it using the screws from the inside once you can get into your trailer.
(click to enlarge)
Product Page this Question was Asked From
Bauer Products Camper Door Lock - Black
- RV Door Locks
- Entry Door
- Locking Latches
- Keyed Alike
- Slam Latch
- 2-3/4 Inch W x 3-3/4 Inch T
- Black
- Bauer Products
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Looking For A Replacement Bauer Lock BP12 For My Horse Trailer
- Q&A: What Do I Need to Direct Hot Air Out of The RV With the Coleman-Mach Underbunk RV AC
- Q&A: Difference Between Global Link RV Entry Door Locking Latch Kit 295-000019 and 295-000021
- Q&A: Best Replacement Locks For Jayco Jay Flight Rebuild
- Q&A: Recommended Flat Towing Parts for a 2019 Jeep Cherokee
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Q&A: Recommended LED Clearance Light that is Red and Amber
- Q&A: Replacement Tail Lights for a 2008 Featherlite 4926 Car Hauler Trailer
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: RV Pre-Departure Checklist
- Article: Must-Have Flat Towing Components
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Trailer Wiring Diagrams
Robin H.
9/29/2025
Hi Simone, did you have a chance to check the cutout dimensions for your Sundowner's paddle door? I'm following up to see if you found a solution, as your experience could help others facing a similar issue.