Will Firestone Air Bag Kit for Georgetown 315 Fit with Motor Mounts
Updated 05/13/2025 | Published 05/11/2025
Question:
I have a 2008 315 Georgetown SE by Forrest River. I have been thinking about adding your Firestone front air suspension kit F2070. However, looking at my frame, I have 2 motor mount bolts sticking down approximately 2 inches, through the bottom of the frame at the position the top mounting plate of the air bag would sit. Does your mounting kit for my motorhome take this into consideration?
asked by: Mike H
Expert Reply:
Hey Mike, if you check out the install picture I attached for the Firestone Ride Rite part # F2070 you can see two bolts that come through the frame. I believe those are the motor mount bolts you are referring to and in front of that you can see where the top bracket of the air bag kit attaches and doesn't interfere. Does that match your setup?
(click to enlarge)
Product Page this Question was Asked From
Firestone Ride-Rite Air Helper Springs - Double Convoluted - Front Axle
- Vehicle Suspension
- Towing/Load Leveling
- Air Springs
- Suspension Only
- Heavy Duty
- Front Axle Suspension Enhancement
- Firestone
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Can I Use the etrailer Awning Fabric on a Solera Awning
- Q&A: Firestone Air Bags for 2026 Ford F-350 FX4 Dually
- Q&A: Replacement Lower Section Recommendation for WFCO 8955 to be Lithium Compatible
- Q&A: Replacement Firestone Ride-Rite Rear Air Bags for a 2000 Ford F-53 Chassis
- Q&A: Best Replacement for a Dometic R2131-BSPFMO Cooktop Oven
- Q&A: Gen-Y Goosebox To Replace Lippert Pin Box LCI Item 2024031630
- Q&A: Installation of Firestone Red Label Air Bags on 2012 Ford F-250 With Block Underneath Jounce Stop
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
Mike H.
5/13/2025
The picture of the frame with the installed airbag you posted is not like my motorhome. I have pictures of mine but no way to attach to your email.