How Deep is the Hitch Pin Hole of Draw Tite Hitch DT73RR
Updated 11/03/2025 | Published 01/13/2025
Question:
What is the distance from the pin hole to the end of the receiver? I need 3-3/8inch for my bike rack wedge to secure.
asked by: Eric
0
Expert Reply:
Hey Eric, on the Draw Tite hitch part # DT73RR the distance from the hitch pin hole to the back of the hitch (towards front of vehicle) measures 5 inches. From the pin hole center to the end of the opening on front of hitch measures 2-1/2 inches.
expert reply by:
Jameson C
0
Continue Researching
- Q&A: Hitch for 2020 Subaru Outback with Best Ground Clearance
- Q&A: Recommended Hitch for a 2023 Subaru Outback
- Q&A: Trailer Hitch Recommendation for 2025 Subaru Outback Wagon
- Q&A: Recommended Trailer Hitch for a 2025 Subaru Outback
- Q&A: Recommended 2020 Subaru Outback Trailer Hitch Receiver and 7-Way Plug With Brake Controller
- Q&A: Recommended Trailer Hitch for a 2021 Subaru Outback Premium
- Q&A: Differences in the Draw-Tite and etrailer Hitches for a 2024 Subaru Outback Wilderness
- Article: Which Hitches are Made in the USA
- Article: Rooftop Cargo Carriers
- Article: How to Choose the Right Trailer Hitch Class
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: How to Measure for Trailer Hitch Drop
- Article: Trailer Wiring Diagrams
Jameson C.
11/3/2025
Hey Eric, did the 2-1/2 inch measurement from the pin hole to the end of the Draw-Tite hitch opening give you enough room for your bike rack wedge? Knowing how that fit worked out could really help others checking clearances for similar setups.