Ramp Spring Recommendation for a 20 ft x 7 ft Equipment Hauler with Adjustable Width Ramps
Updated 06/03/2014 | Published 06/02/2014
Question:
I have a 20 ft x 7 ft Eqpt trailer with two 7000 lb axles and two ramps that slide side to side to adjust for wheel spacing. The ramps have no lift assist. The hinge rod is 1.5inch diameter. Will your lift springs work on this setup? Thanks
asked by: Marty
Expert Reply:
Yes, the Ramp Spring - 2K Torque for 1-1/2" Shaft - RH # RS16933RH would work on the right side of your trailer and the Ramp Spring - 2K Torque for 1-1/2" Shaft - LH # RS16933LH would work for the left hand side of your trailer.
Both of these springs are designed for use on 1-1/2 inch diameter shafts so they would fit very well. I attached a picture we got from a customer who used these springs on an adjustable width ramp just like you plan on doing.
Product Page this Question was Asked From
1/2" Diameter Greasable Hinge Pin, 4-1/2" Long
- Accessories and Parts
- Trailer Door Hinges
- Trailer Door Parts
- Hinge Pins
- Redline
more information >
Continue Researching
- Q&A: How is Pin of Trailer Barrel Hinge Secured
- Q&A: Is There a Replacement 4-Pin, DPST Rocker Switch
- Q&A: Replacement Lid Options For A Dometic FV5300 RV Roof Vent
- Q&A: Replacement Motor for Fan-Tastic Roof Vent 5300
- Q&A: Where To Mount The TST TPMS Repeater On A 2020 Grech Strada RV
- Q&A: Replacement Hub and Drum With 25580 Inner Bearing and LM67048 Outer Bearing
- Article: Most Popular Wheel Bearings
- Q&A: Replacement Ramp Gate Pin Latch For Carry On Utility Trailer From Tractor Supply