Solution for Replacement Hub for 1969 Orbit Trailer With LM48548 Inner and L44648 Outer Bearings
Updated 12/15/2025 | Published 11/20/2024
Question:
I have a 69 orbit 15’ trailer I need to replace the wheel hubs the inner bearing is LM48548 and the outer bearing is L44648. What hub will fit this is not. 4 lug 6 1/2 pattern Thanks Ron
asked by: Ron O
(click to enlarge)
(click to enlarge)
Helpful Expert Reply:
Hello Ron; I'm sorry to say that we do not have a hub that matches that bearing combination. It is not uncommon for an older trailer like yours to have an obsolete bearing combination with no available replacement hub. Unfortunately, that means the only option is to replace the axle and switch to hubs that use a modern bearing combination. You will need to know the axle capacity as well as the hub face measurement to find a replacement.
Product Page this Question was Asked From
Square #84 Spindle for 3,500-lb Trailer Axles - 1-1/2" Wide
- Trailer Spindles
- Standard Spindle
- Without Flange
- L68149
- 1-1/2 Inch Diameter
- Square
- For 3500 lb Axle
- TruRyde
more information >
Continue Researching
- Q&A: Length of Parking Brake Kit Cable
- Q&A: Who Makes The Best Quality Trailer Bearings?
- Q&A: Where to Measure on Trailer Spindles to Determine Replacement Hubs
- Q&A: Should Trailer Equalizers have Side to Side Movement When Installed
- Q&A: Weld-On Spindle for Trash Trailer Without Suspension
- Q&A: What Size and Thread Pitch is the CE Smith Tapered Spindle Axle CES98WR?
- Q&A: Recommended Replacement Square 1.5" Spindle for a Boat Trailer
- Article: Trailer Wiring Diagrams
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Where to Position the Trailer Axle?
- Article: Most Popular Wheel Bearings
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Double-Eye Trailer Suspension System Review
Robin H.
12/15/2025
Hey Ron, were you able to find a replacement axle for your 15' Orbit trailer after checking the capacity and hub face measurement? Knowing what worked could help others with older trailers facing the same issue.