Availability of Hitch that Could Fit 2008 International IC RE Bus
Updated 12/15/2025 | Published 11/20/2024
Products Featured in This Question
Question:
I need to get a 10K at minimum tow hitch for a 2008 international IC RE Bus
asked by: Derek D
0
Expert Reply:
Hey Derek, only solution would be a universal Class V hitch like the # C87CR as we don't have anything custom fit for your bus. This has drop brackets that can be set at any width up to 44 inches so it should hopefully be something that would work for you but you would need to check out the rear of your bus. The drop these brackets have is 18 inches.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class IV - 2"
- Trailer Hitch
- For Towing
- Class IV
- 1000 lbs TW
- 10000 lbs GTW
- 12000 lbs WD GTW
- 2 Inch Hitch
- 1200 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Installing Curt Hitch on 2005 Ford F-350 Cab and Chassis
- Q&A: Dimensions of Curt Trailer Hitch C14048 for Ford Cab and Chassis Trucks
- Q&A: Trailer Hitch Side Brackets and Mounting Hole Dimensions for 2009 Ford F-Series Cab and Chassis
- Q&A: Side Plate and Bolt Hole Spacing Measurements for Curt Trailer Hitch # C14082
- Q&A: Mounting Hole Dimensions of Curt Trailer Hitch C14048 for Cab and Chassis
- Q&A: Bolt Hole Spacing of Curt Class IV Hitch Receiver 14082
- Q&A: Does Draw-Tite Class IV Hitch Fit 2004 Forest River Georgetown SE on F-53 Chassis
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Article: Stability Control for Heavy Duty Vehicles
- Article: Trailer Hitch Installation Tips
- Article: Trailer Hitch Receiver Sizes
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
Jameson C.
12/15/2025
Hey Derek, how did things work out with the universal Class V hitch for your bus? Were you able to get the brackets lined up with the rear frame the way you needed? Your update could make it easier for the next person working on a similar setup.