Surface Mount Light With Motion Sensor for Refrigerated Trailer
Updated 12/22/2025 | Published 10/26/2024
Products Featured in This Question
Question:
Looking for a surface mount light kit with motion sensor built in for a 53’ refrigerated trailer. Preferable IP65 rated. Looking for lights and wiring with some type of trim/conduit to hide the wiring. Thank you
asked by: Jonny D
Expert Reply:
Hi Jonny; the only surface mount light we have with a sensor is the # 3375625338 you were looking at. This doesn't have the IP65 rating and the timer only stays on for 23 seconds if no other motion is detected so that probably isn't what you want.
If you decide a recessed mount light could work we also have the Great White LED Dome Light for Refrigerated Trucks and Trailers # M365. This is a great choice since it is rated for temperatures down to -55º F and has a long 5 minute timer ideal for a trailer like yours. The downside here is cutting into the trailer to mount it.
I don't have a lot of experience with refrigerated trailers but I would imagine if you add some extra insulation behind it and seal it up nicely it won't be a problem. If connecting to power is an issue I'm sure you could get away with using longer screws to surface mount the light with the flange sticking out and then run some basic wire loom # 39035 to cover the wires.
Before you try to rig something up it may be worth reaching out to a company that manufactures or makes parts for refrigerated trailers to see if they're aware of a light that meets all of your requirements as is.
Product Page this Question was Asked From
LED Trailer Dome Light w/ Motion Sensor - Surface Mount - 2,200 Lumens - White Base - Clear Lens
- Trailer Lights
- Interior Lights
- Round
- Surface Mount
- LED Light
- 5-1/8 Inch Diameter
- White
- Buyers Products
more information >
Continue Researching
- Q&A: Replacing Ramp Springs On Featherlite Snowmobile Trailer
- Q&A: How do you Replace the Internal Housing and Foot Plate on the Pro Series Square Jack # PS1400850383
- Q&A: Replacement Gear Set for Pro Series 1400850383 and Bulldog BD190754 5K Capacity Trailer Jack
- Q&A: Is 3/4 Inch Plywood Floor Adequate for D-Ring Tie Down Anchors with Backing Plate for 3,000 lb Car
- Q&A: Recommendation to Convert Generator Power to 12V 7-way Trailer Connection
- Q&A: What Wiring Options Are Available To Power The Bulldog Powered Trailer Jack
- Q&A: Replacement For Atwood GC6AA/10E 6-Gallon Water Heater
- Article: How to Install E-Track in 3 Easy Steps
- Article: Most Popular Wheel Bearings
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Article: Cargo Tie-Down Methods
- Article: Trailer Lighting Requirements
- Article: How to Choose the Best Winch for You, your Boat, and your Trailer
- Article: Finding the Right Electric Winch
Robin H.
12/22/2025
Hey Jonny, were you able to find a light setup that met your IP65 and motion sensor needs for the refrigerated trailer? Knowing what worked could help others trying to light a similar setup.