Looking for Replacement Brake Assembly for 1988 Kaylan Siebert Trailer with 8k Axles
Published 10/16/2024
Question:
We have a 1988 Kaylan Siebert trailer with 8k lb axles. We need new brakes. Looks like these are the right fit, wondering what the 4-bolt mounting pattern size is. Ours is 3 3/4 inch bolt pattern, square. Thank you
asked by: Todd C
Expert Reply:
Hey Todd, there is a good chance the part # 23-403 that you referenced is the correct brake assembly for your 1988 Kaylan Siebert but due to the age of your trailer and the fact that 8k axles aren't quite as standardized as lower capacity axles I would recommend you do some measuring to be absolutely sure.
Your drum diameter should be 12-1/4 inches and the width of the current brake pads should be 3-3/8 inches.
The 4 bolt pattern of this assembly is 3-5/8 inches from left to right and then vertically 3-7/16 inches.
Product Page this Question was Asked From
Dexter Hydraulic Drum Brake Assembly - Duo Servo - 12-1/4" - Right Hand - 8,000 lbs
- Accessories and Parts
- Trailer Brakes
- Hydraulic Drum Brakes
- RH
- 8000 lbs
- Brake Assembly
- Dual Servo
- Self Adjust
- 12-1/4 x 3-3/8 Inch Drum
- Dexter
more information >
Continue Researching
- Q&A: Replacement Brake Assemblies and Hub/Drums for 15k Dexter Axle
- Q&A: What Is The Correct Oil To Use In My Dexter Axles With Oil Lube Bath Hubs?
- Q&A: Troubleshooting Dexter Electric Over Hydraulic Trailer Brake Actuator Cycles On and Off
- Q&A: Difference Between Single, Dual and Free Backing Servo Brake Assemblies
- Q&A: Does The Replacement Brake Shoes For Titan Hydraulic Trailer Brakes Fit The Left And Right Hand Side
- Q&A: Comparing Free Backing and Duo Servo Hydraulic Brake Assemblies
- Q&A: What is Weight Capacity of Load Range E Trailer Tire in Size ST225/75R15
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: How to Choose the Right Trailer Hitch Class
- Article: Gooseneck Trailer Hitch Information and Review