Does LockRack Adapter # LR44VR Fit Thule Wingbar Crossbar

Question

Question:

Will this work on a Thule Wingbar Aero? Im trying to find some way to attach accessories such as a load stop since Thule is very limited in what they off for this rack. Had I know...ugh...

asked by: George

0

Expert Reply:

Hey George, yes the LockRack adapter part # LR44VR that you referenced does fit around the Thule Wingbar crossbar.

expert reply by: Jameson C

0

George

10/8/2024

Jameson, Thanks very much for the quick response, and good news that it will fit.

Jameson C.

10/8/2024

@George Glad to help!

Answer 1

The Inno Locker Watersport Carrier - Locking - Channel Mount #INXA445 will definitely fit with the channels on the Thule WingBar Evo Crossbars! I really like the channel mount system because it looks a bit more clean since there isn't a whole…

view full answer...

Answer 2

Both the Lockrack Surfboard #LR59FR and SUP Rack #LR47FR are only capable of carrying a single surfboard. We do have the Rack #LR67VR from Lockrack which can carry 2 small surfboards. If you have large boards you will want to consider looking at the…

view full answer...

Answer 3

I have a couple of options for you for bolts that are compatible with the T-slots in the Wingbar Evo's but the Rhino Rack item #RR92XB do not fit. Instead you will want one of the following: Replacement Square Head Bolt - 6 mm x 61 mm item…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 10

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 11

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Does LockRack Adapter # LR44VR Fit Thule Wingbar Crossbar

Continue Researching