Turn Signals Work But Tail Lights Don't On a 2018 Forest River Sunseeker 2300
Updated 01/05/2026 | Published 09/22/2024 >
Question:
2018 Forest River Sunseeker 2300. If the tail light doesnt work, but turn signal and brake light functions do, would you just replace the entire light or is it possibly something else?
asked by: Bob H
Expert Reply:
Bob, it's very likely that the light isn't the issue, but rather your wiring. In these cases, it's almost always a bad or damaged ground connection that's causing the issue, so I'd suggest checking that and making sure that nothing is damaged or loose.
If your wiring turns out to be good, and you're getting voltage to the light, then the light itself is the issue and would need to be replaced.
Product Page this Question was Asked From
LED Trailer Light w/ Reflector - Brake, Turn, Tail - Passenger Side - Oval - Red
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn
- Oval
- Surface Mount
- Non-Submersible Lights
- LED Light
- 9-1/2L x 4W Inch
- Red
- Command Electronics
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: How to Remove Lens From Command LED Trailer Tail Lights # 328-003-85L and # 328-003-85
- Q&A: Replacement Clearance Lights For Glo Brite 122r/122y
- Q&A: Replacement Tail Lights for 2018 Jayco Alante Motorhome
- Q&A: Recommended Trailer Hitch for a Volvo D13 Semi-Trailer
- Q&A: Replacement Toilet For Travel Trailer With SC 310 Toilet
- Q&A: Is There Replacement Flush Ball for Dometic 310 Toilet
- Q&A: Recommended Replacement Door Lock for a TriMark 1993/72130
- Article: Trailer Lighting Requirements
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)


Jesse M.
1/5/2026
Hey Bob, what ended up being the cause of the tail light issue on your Sunseeker? Did checking the ground connection take care of it, or did you end up replacing the light? Your update could make it easier for others troubleshooting the same problem.