Will 11.5" Gustafson Light Have Closer Mounting Points Than the 12" Optronics Light
Updated 01/05/2026 | Published 09/18/2024
Products Featured in This Question
Question:
Good Afternoon to you, i bought a ceiling light to replace in an 03 model, am wondering if i had bought the half inch smaller light if the screws would be located narrower, as my old one is a screw pattern- only one screw at lateral ends. If you’ve happened to seen or worked on these things. Thanks.
asked by: Cortney
0
Expert Reply:
Hey Cortney,
The Optronics 12V RV Dome Light # RVIL22 you purchased will have at least the same dimensions, if not closer together, than the Gustafson 12V LED RV Dome Light # 277-000340 you're looking to replace it with.
expert reply by:
Jon G
0
Product Page this Question was Asked From
Optronics 12V RV Dome Light - Double - 12" Long x 4-1/4" Wide - White Housing
- RV Interior Lights
- Dome Light
- Bright White
- On/Off Switch
- Surface Mount
- Incandescent Light
- 12V
- White
- Optronics
more information >
Continue Researching
- Q&A: Is There MCD Innovations RV Shade Repair Kit that Comes with Motor Motor 50.336
- Q&A: What Propane Gas will Replace My CCI Controls Model No. 7719 LP Gas Leak Detector?
- Q&A: Installation of Emergency Break Away Cable Repair Kit for Dexter Axle A-60 Brake Actuators
- Q&A: Replacement Converter for a WFCO 8735-AD
- Q&A: Brightest Interior Trailer Light Recommendation
- Q&A: Brighter RV Interior Dome Light that is LED
- Q&A: Are There Any 2" Wide Piano Hinges With A 1/4" Pin And 83-1/2" In Length
- Article: Trailer Wiring Diagrams
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Ugly RV Makeover: How to Change Outdated RV Lighting
- Article: Holiday 2025 | RVers’ Favorite Gear & Road Picks
- Article: Holiday 2025 | Best Gifts for Towers
- Article: Holiday 2025 | Best Gifts for RVing
Jesse M.
1/5/2026
Hey Cortney, how did the fit go with the Optronics dome light compared to your old one? It’d be great to know if the screw spacing lined up the way you hoped. Your update could make it easier for the next person replacing a similar light.