Roller Shaft Diameter for CE Smith Keel Roller Assembly for 3" Wide Trailer Tongues

Question

Question:

I believe my assembly is the same and want to order a new roller shaft prior to removing the old one and need to know the diameter and length of the roller shaft on this assembly. Im guessing it may be 5/8inch diameter x 6 1/4inch shaft. Can you please confirm? Note: 3inch trailer tongue on our trailer.

asked by: Dave

0

Expert Reply:

Hey Dave,

The CE Smith Keel Roller Assembly for 3" Wide Trailer Tongues # CE32003G has a 5/8" shaft, yes.

expert reply by: Jon G

0

Dave

9/3/2024

Jon thanks but I also need to know the length to order the correct length of shaft. I had guessed it may be 6 1/4" length as that size was closest size that appeared may be correct. I tied contacting CE Smith directly but it appears earlier they were having some sort of server issues.

Jon G.

9/4/2024

@Dave It should have a 6-1/4" shaft but at this point in time I don't have a way to get my hands on it to check. Since this comes as a whole kit and is designed to fit a 3" wide trailer tongue you'll be able to use the shaft that comes with this kit just fine.

Answer 1

You will only need one keel roller assembly, and I recommend the CE Smith - which is also made in the USA - because they come with a full assembly as opposed to having to piece together parts, which can be more costly. You only need to choose the one…

view full answer...

Answer 2

Hey Danny. I took a look at our options and I do not have anything in a 9" roller and bracket that's going to work for your Holsclaw boat trailer. We have quite a few keel rollers like the 12" Wide item #CES94JR. You would need the…

view full answer...

Answer 3

Since the picture you submitted belongs to Karavan I can't post it here on our site, but if you check out the attached picture you can see how a very similar trailer had a set of rollers like the part #CE27710 installed. For a set of swivel…

view full answer...

Answer 4

Hey Beth, welcome back. Yes, you can usually move both the spare tire mount and the kickstand forward on a Malone LowBed as long as there is room. Those components are clamped to the tongue, so physically sliding them closer to the coupler is doable,…

view full answer...

Answer 5

I do have a solution for you but we don't offer any integrated winch and bow roller setups like the Knot Autoflex. Therefore, you'd have to purchase a winch stand assembly like the CE Smith Winch Stand part #CE31013G which bolts onto the…

view full answer...

Answer 6

To replace your NOK AD2527E seal you can use #168233. It has an inner diameter of 1.688 inches and an outer diameter of 2.332 inches. Based on what I could find on the NOK AD2527E the inner diameter is the same and the outer diameter is 2.328 inches.…

view full answer...

Answer 7

The brown wire of trailer wiring is the running light/marker light circuit and the white is ground. So on your setup that has a brown wire that would be where you'd run the marker light circuit to and then the white would get the ground circuit.…

view full answer...

Roller Shaft Diameter for CE Smith Keel Roller Assembly for 3" Wide Trailer Tongues

Product Page this Question was Asked From

Continue Researching