Replacement For 90" x 6" Fisher Snow Plow Blade With Mounting Holes 12-7/18" Apart
Updated 01/19/2026 | Published 08/13/2024 >
Question:
Want replace a urethane, 89 7/8”x 5”x 1” plastic urethane edge for a 7.5’ Fisher plow, bolt holes are 12 7/16 apart, end holes 1 1]” from ends.. Will your 90”x6”x3/8” carbon steel edge blade work..? My Fisher Plow is 20 years old and I am sue the blade was 6” wide at one time… Take eight 1/2” bolts
asked by: Kevin S
Expert Reply:
Hi Kevin,
From all of the numbers you stated, yes, the Replacement Cutting Edge for Fisher Snow Plows - Carbon Steel # 3371301300 will work.
The # 3371301300 meets all of the specs you mentioned, with eight mounting holes that accept 1/2" bolts and are 12-7/16" apart.
Product Page this Question was Asked From
Replacement Cutting Edge for Fisher Snow Plows - Carbon Steel - 7-1/2' Long x 6" Tall
- Snow Plow Parts
- Fisher Plow Parts
- Cutting Edges and Blades
- 90 Inch Long
- Cutting Edges
- SAM
more information >
Continue Researching
- Q&A: Installation Time for Blue Ox BX1128 Flat Tow Base Plate Kit for 2016 Jeep Grand Cherokee
- Article: Trailer Wiring Diagrams
- Q&A: What Replacement Blade and Mounting Bolts Work with My Fisher Snow Blade 5532?
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Q&A: Replacement Bearings, Races, and Seal for Hub that Uses 28580 and 25580 Bearings
- Q&A: Is There a Replacement Spindle For a Dexter D44, 4400LB Trailer Axle?
- Q&A: Correct Replacement Grease Seals for Dexter 4400 Lb Capacity Axle
- Q&A: New LED Lights Causing Hyperflashing On Flat Bed Truck
- Q&A: Replacement Brake Drum Hub Assembly For Dexter D44 4,400LB Axle


Gwendolyn Y.
1/19/2026
Hey Kevin, how did the new carbon steel cutting edge work out on your Fisher plow? Did it line up well with the bolt holes and give you the fit you needed? Your update could make it easier for others replacing older urethane edges.