Recommended Replacement Inner Jack Tube for a 2" Square Jack
Updated 07/29/2024 | Published 07/26/2024
Question:
I’m looking for a leg which would slide into a 2” square jack. Measurement of the leg I need is approx 1 11/16” square. Do u carry like this? Thanks!
asked by: James J
0
Expert Reply:
James, it looks like the Replacement Drop Leg for Bulldog Square Trailer Jacks # BD500270 will work. This jack will work with trailer jacks that have a square 2" inner tube, and has a 8,000 lb capacity.
This inner tube will work with Bulldog trailer jacks so if you have a different jack let me know and I can take a look at what we have.
expert reply by:
Bryce D
0
Product Page this Question was Asked From
Replacement Drop Leg for Bulldog Square Trailer Jacks - 18" - 8,000 lbs
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Legs
- Drop Leg
- 2 Inch x 2 Inch Tubing
- Bulldog
more information >
Continue Researching
- Q&A: Recommended Stabilizer Supports For Equipment Trailer That Lifts Back Of Truck Off The Ground
- Q&A: Looking to Install the etrailer Hitch e98912 on My 2025 Subaru Crosstrek, Can I Use Smaller Hardware
- Q&A: How to Position the Lippert Shocks on a Single Axle Trailer
- Article: Big Truck Big RV
- Q&A: Factory Location for Brake Controller Wiring Harness Install on 1996 Ford F-250 or F-350 Models
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: Square Drop Leg Stabilizer Jack Tube and Pin Hole Diameters
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Q&A: What is the Correct Hub Replacement for Dexter 8-208?
- Q&A: Replacement Coupler for Dico 17550 Weld-On Coupler
- Article: Trailer Jacks
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Trailer Lighting Requirements
- Article: Rooftop Cargo Carriers