Replacement Gear Set for Fulton 1000-lb Tongue Jack
Updated 05/13/2014 | Published 05/11/2014
Question:
my gears stripped out on a Fulton 1000lb capacity tongue jack, the handle gear. Ive looked and are unable to find a beveled gear set replacement, BECAUSE my current handle gear is pinned thru the gear itself, the sets online show that the gear pin sits behind the beveled gear. can you help me find the replacement? NOTE: the pin going thru the gear is what holds the handle in place, not allowing it to slide out of the jack.
asked by: Bill P
Expert Reply:
It is not possible to identify the correct replacement gear set for your Fulton tongue jack based just on your description. My technical contact at Fulton confirmed you will need to find the jack's part number, usually stamped into the outer tube, as well as advise if it is a top-wind or side-wind type.
Product Page this Question was Asked From
Replacement Bevel Gear Kit for Fulton Jacks - 800 - 1,200 lbs
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Motor and Gear Parts
- Gears
- Fulton
more information >
Continue Researching
- Q&A: Grease Seal Recommendation to Replace AD2527E
- Q&A: What Is The Thickness Of The Replacement Gear Kit For Etrailer And Ram Sidewind Jacks
- Q&A: Replacement Follow Landing Gear Leg for 1998 Fleetwood Savanna 5th Wheel
- Q&A: Replacement Parts for Fulton F2 Dual Wheel Trailer Jack
- Q&A: Mounting Hardware Only for Thule Hullavator Kayak Carrier
- Q&A: Replacement HappiJac Camper Jacks Option For A 1997 Northstar Pop-Up Camper
- Q&A: Replacement for Shelby Industries Model 5756 Boat jack
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups