Wiring LC27WJ Controller In Place Of Power Gear 510116 - What Wires Go To What?
Updated 05/24/2024 | Published 05/18/2024
Question:
On the new controller it says switch in and switch out. Question is which is which on old contoller? where do wires sw rev and sw forward go on new one?
asked by: Steve B
0
Power Gear 510116 Controller
(click to enlarge)
(click to enlarge)
Expert Reply:
Hello Steve. I contacted Lippert to confirm this.
SW REV (reverse) SW FWD (forward). Reverse is in and Forward is out. So, SW Reverse will go to Switch In on the new controller. The SW forward will go to Switch Out.
expert reply by:
Jesse M
0
Product Page this Question was Asked From
Replacement Sensing Control Panel for Power Gear Single Rail Above Floor Sofa Slide-Out
- RV Slide Out Parts
- Motor Parts
- Motor
- Lippert Above-Floor Slide-Out Systems
- Lippert
more information >
Continue Researching
- Q&A: Replacement for Power Gear Slide-Out Controller 510116
- Q&A: Correct Replacement Controller for a Power Gear 140-1163 for a Fleetwood Slide Out
- Q&A: Is The Lippert Slide Out Switch LC117461 A 4 Wire Or 5 Wire Switch.
- Q&A: Troubleshooting Slide Out Switch To Controller Wiring Issues
- Q&A: Will Lippert Slide-Out Controller Work To Bypass Factory Slide-Out Wiring
- Q&A: Replacement Control Sensor for Power Gear Slide Out Controller # 1510000013
- Q&A: Replacement Slide Out Control Module And Wiring Harness For A Power Gear 510116
- Article: Most Popular Wheel Bearings
- Article: Flat Towing Package for 2007-2018 JK Jeep Wrangler and Wrangler Unlimited
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)