Friction Sway Control Installation Recommendation on a 2007 Starcraft 2406 Pop Up

Updated 04/30/2014 | Published 04/29/2014

Question:

Hello, I was about to order this for my pop-up camper when I noticed that the pop-up tent connector was located near where the installation video said to install the stabilizer bar Ive attached a couple of photo. Is that not going to be a problem, or there something that I am missing, or is there an alternate product that I can install for my 2007 StarCraft 2406 pop-up camper? Im concerned about driving up in the mountains, or on high-wind days without a stabilizer bar. Thanks, Chris

asked by: Christopher H

Expert Reply:

Is there anything on the other side of the trailer frame? If not, you could just run the Reese Sway Control part # 83660 on the other side of the trailer and you would be good to go.

You would just need to loosen the sway control unit enough that you could slide the inner piece out and then flip it 180 degrees and reinsert it and it would be ready to use on the other side of your trailer.

I attached an install video for this product for you to check out also.

expert reply by: Jameson C