Curved Portion of Lippert 5th Wheel Landing Gear Dimension
Published 04/18/2024
Question:
I have a 2020 Grand design reflection 303rls with a broken bracket. What is the measurement on the bracket where the curve in the middle is? This would be the distance the jack will sit away from the RV wall/frame.
asked by: Neil C
0
Expert Reply:
Hey Neil, so the dimension you are looking for is 3/4 inches. This is the distance from the top of the bracket down to the inside portion of the curved part of the bracket.
expert reply by:
Jameson C
0
Bracket Dimension
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Replacement Weld-On 5th Wheel Landing Gear Leg Bracket for Lippert RVs
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Mounting Hardware
- Brackets
- Lippert
more information >
Continue Researching
- Shop: Replacement Weld-On Mounting Brackets for Stromberg Carlson Landing Gear - Qty 2
- Shop: Replacement Weld-On 5th Wheel Landing Gear Leg Bracket for Lippert RVs
- Q&A: How To Install the Landing Gear Set Part # RVLG-8000
- Q&A: Replacement Landing Gear Bracket for an LCI Landing Gear On An 2019 GD Reflection 5th Wheel
- Q&A: Installation of etrailer Landing Gear
- Q&A: How do Lippert Ground Control 3.0 Leveling System Landing Gear Jacks Mount to Trailer
- Q&A: Dimensions of I Beam Bracket for Lippert Ground Control Leveling System
- Q&A: Mounting Plate Height of Replacement I-Beam Jack Bracket for Lippert Ground Control
- Q&A: Can The Auto-Level Feature Be Used On A Lippert Ground Control 3.0 System With A Damaged Leg
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Where to Position the Trailer Axle?
- Article: How to Raise Your Travel Trailer Height
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Best Camper Jacks