Do You Cut Tabs on Both Stacked SeeLevel Sensors SE88VR
Updated 03/05/2024 | Published 03/04/2024 >
Question:
SEELEVEL SENSORS 710-AR When stacking the sensors do you have to cut the tab on both sensors or just one?
asked by: Jacob
0
Expert Reply:
Per SeeLevel, for a stacked configuration of the SeeLeveL Sensor for RV Holding Tank Monitor - 9" Long # SE88VR you just cut the top sensor.
expert reply by:
Kyle S
0
Product Page this Question was Asked From
SeeLeveL Sensor for RV Holding Tank Monitor - 9" Long
- Smart RV
- Monitoring System
- Water Tanks
- No Display
- Monitors Only
- SeeLeveL
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommended Power Winch For Raising Enclosed Trailer Door Ramp
- Q&A: Is there a Powered System to Raise and Lower a Ramp Door on a Toy Hauler Trailer
- Q&A: Dutton-Lainson TW4000 StrongArm Electric Winch # DL25200 Shuts Down When Under Load
- Q&A: Using an Electric Winch to Raise and Lower a Ramp Door on a Logan Horse Trailer
- Q&A: Replacement Single Zone Dometic Thermostat for Model 3313196
- Q&A: Difference Between Trailer Tires Continental 235/75R17.5 HTR2 LRH and Provider 235/75R17.5 LRJ P3517
- Q&A: Replacement Kwikee Control Module for Part Number 1510000140
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: The Definitive, Step-by-Step Flat Towing Setup Guide
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: How Does an RV Water Pump Work?
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: The Ultimate RV Camping Checklist for Your First Year RVing

