Looking To Redo Roof On A 2010 Keystone Passport Ultralite

Question

Question:

Hi I have a 2010 Keystone Passport Ultralite and I am looking to redo the roof. I would like to replace all of the skylights, vents, etc. that are on the roof. I want to make sure I get the correct ones? Are you able to spec those out for me? Thanks.

asked by: Christopher M

0

Expert Reply:

Hi Christopher,

There unfortunately isn't a guide to tell us the exact part numbers for the vents, skylights, etc. on your Passport. We offer a variety of plumbing vents and 12v fan vents but we unfortunately do not offer skylights. If you want to send some pictures and measurements on the plumbing vents in then we can figure out the best replacements, for the 12v fan vent I'd want your opinion on the features you'd prefer for the roof vent.

The MaxxFan Mini Plus Manual RV Roof Vent w/ 12V Fan # MA00-03851 is a great option if you have other items on the roof and don't have the clearance for a lifting lid, but you'll have a lower CFM rating. This vent moves air at 200CFM whereas a lifting lid version like the # MA00-05100K has a 900CFM rating.

For the refrigerator vent we'd need to know the cutout hole size in order to find the correct replacement.

If you haven't picked out the replacement roof materials then I recommend checking out the Alpha Systems Superflex TPO RV Roof Membrane # AL32CV along with their installation kit # AL74UV to get everything you need.

expert reply by: Kevin C

0

Answer 1

Hey Stanley! To clear things up, you need to connect the white plug. However, this is definitely confusing. I just looked at the #FR27TD instructions and I see where it says to tuck the white connection off to the side, unused. Directly below that it…

view full answer...

Answer 2

Hey Don, thanks for reaching out! The Furrion Chill Cube #FR99TD does have provisions built in to lower the amount of power required to start the unit up. I don't think Furrion officially calls it a soft start (there's debate about that…

view full answer...

Answer 3

Hey Mark, the oscillating vent of the Furrion Chill Cube #FR27TD points to the front. Is there anyway you could use it pointing forward?

view full answer...

Answer 4

Hello Harold, thanks for reaching out. The SumoSprings Maxim Custom Helper Springs #SSR-106-47-1 are the correct fit for your 2022 Nexus Viper/Ford E450. The 7" of clearance is the bare minimum for them to fit, so as long as you have 7" or…

view full answer...

Answer 5

Hey Clayton, thanks for reaching out! Just so we're on the same page, it sounds like you're looking for replacement slide-out awnings as well as the standard awning that hangs out over the entry door. I'll definitely be able to help you…

view full answer...

Answer 6

The MaxxAir Mini Deluxe Trailer Roof Vent part #MA00-03851 once installed will sit almost flush with the ceiling. The panel which houses the light and control knob I would say is around 1/4" - 1/2" thick so that is all that would sit inside…

view full answer...

Answer 7

Hey Clayton, thanks for reaching out! For a plug and play replacement AC unit you'll need to go with the Furrion Chill HE #FR32PV. This comes with an adapter that makes it compatible with directly with the wiring from your older Duo-Therm. Did…

view full answer...