Will A Ventline Replacement Lid Work With A MaxxAir MaxxFan Dome Roof Vent

Question

Question:

Does this replacement vent lid work on a MaxxAir round dome vent fan? My foam under the lid has a piece that dropped down in the open position.

asked by: Barb

0

Expert Reply:

Hi Barb,

Replacement lids like the # BVA0502-03 are unfortunately brand specific so it would not be a fit with your MaxxFan Dome Roof Vent # MA00-03812B. We don't currently offer the replacement lid for this model so I recommend reaching out to MaxxAir directly and I'm sure they'd be happy to send you a replacement. If not then you'd be looking at buying a replacement secondhand or completely replacing the vent. I'm also not quite sure if anything else might be damaged with your vent to where you wouldn't be able to just replace the lid so if you want to send in some pictures I could take a look first.

expert reply by: Kevin C

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

The foam ring on the Ventline Vanair Trailer Roof Vent part #VP-543SP is a weather seal that is used to help seal the dome on the fan assembly. If you continue to use the fan without the foam ring you would be subjected to leaks which could then…

view full answer...

Answer 4

You can use the RV Propane Gas Detector #RS64FR to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 5

Hi Bill, If you do in fact have a Ventline Ventadome or Vanair RV roof vent then you'll be able to replace the motor with #BVD0218-00. I recommend removing the old motor and seeing if there are any serial numbers on it that we can use to…

view full answer...

Answer 6

I wasn't able to find much information on the exact replacement for your Ventline AS-13 M-VA 203 roof vent. The only information I found said it had an overall width of 8-1/2" and uses a 6" fan. It sounds like you will need the…

view full answer...

Answer 7

The actual puck itself is a standardized size between each brand so the only measurement that matters is the spacing of the pucks, which differs between each vehicle manufacturer. I've attached a diagram below with the spacings used by…

view full answer...

Answer 8

The TorkLift PowerArmor Locking Battery Box - 6V and 12V Lithium Batteries #TLA7700L weighs approximately 30lbs.

view full answer...

Answer 9

Yes, the Replacement 17-rpm Lift Motor for Fan-Tastic Vent B Series #FVK6010-80 can be used in place of the 7-rpm Lift Motor FVK6050-80, as long as you swap the wires like you mentioned.

view full answer...

Will A Ventline Replacement Lid Work With A MaxxAir MaxxFan Dome Roof Vent

Product Page this Question was Asked From

Continue Researching