Can Holes be Drilled in UWS A-Frame Trailer Toolbox
Published 10/31/2023
Question:
I am looking at this to replace a current plastic- open bottom box that holds my RV battery just one deep cycle and one propane tank. I read the answer about venting- could holes be drilled in the back or bottom of the box to allow for venting? My concerns are thieves, bees and critters.
asked by: Bonnie S
1
Helpful Expert Reply:
Yes, you could drill holes in the UWS A-Frame tool box part # UWS01039 to allow for venting or battery lines ran to it like you asked about.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
UWS A-Frame Trailer Toolbox - 6.3 cu ft - Bright Aluminum
- Trailer Tool Box
- A-Frame Tool Box
- 19 - 22 Inch Tall
- Aluminum
- 41 Inch and Longer
- Silver
- UWS
more information >
Continue Researching
- Q&A: Front To Back Measurement On Buyers Products Trailer Tongue Toolbox
- Q&A: Recommended Trailer Tongue Tool Box to Hold Two Propane Tanks
- Q&A: Can I Put Four 6 Volt Batteries in the Buyers Products Trailer Tongue Toolbox 3371701385?
- Q&A: What is the Best Way to Jack Up a Boat Trailer with Torsion Axles
- Q&A: Will Hydrastar Disc Brake Kit HYD44VR Fit Tandem Axle Trailer with 6k Axles
- Q&A: Protecting Trailer's 7-way Trailer Connector from Moisture
- Q&A: Confirming If ARK Xtreme Off-Road Swing-Up Jack will Fit a Trailer With 6.75 Inches Clearance To Box
- Article: How to Measure for Trailer Hitch Drop
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Maintenance Schedule
- Article: Trailer Wiring Diagrams
- Article: Still Rocking After Leveling? How to Stabilize Your RV for Good
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)