What are the Handle Dimensions on Pro Series 5k Side Wind Trailer Jack
Published 04/03/2014 >
Question:
What are the dimensions on the handle?
asked by: Joel L
0
Expert Reply:
I went out to the warehouse and pulled the Pro Series trailer jack # PS1401600383 to measure the handle. I have included a video showing the measurements I took.
The overall height of the handle is about 7 inches.
From the jack tube to the end of the handle it sticks out 5-1/2 inches.
From the End of the handle to the vertical part of the handle it measures 4-1/4 inches.
From the top of the jack to the top of the handle when it is sticking straight up it is 4-5/8 inches.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Pro Series Square Jack with Footplate - Drop Leg - Sidewind - 28-5/8" Lift - 5,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Side-Mount Jacks
- Standard Grade
- 4001 - 5000 lbs
- Manual Jack
- 29 Inch Lift
- Weld-On
- With Rectangle Foot
- Pro Series
more information >
Continue Researching
- Q&A: Is There A Motor Kit For The Bulldog Square Jack BD180455?
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: How Many Batteries Do You Need to Run RV Air Conditioner?
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: The Upgrades: Firestone Air Command Kits
- Q&A: How to Activate 12V Trailer Power Circuit on 2017 Ford F-350 Super Duty
- Q&A: Stabilizers Needed for 6x10 Cargo Trailer for ATV
- Q&A: Recommended Lithium Batteries To Replace Lead Acid Group 24 Duralast Batteries
- Q&A: Info on Lithium RV Battery for Off Grid Camper
- Q&A: How to Power 12V Refrigerator While Driving
- Q&A: Will RVs Lithium Battery Harm Vehicle 7-Way
- Article: Trailer Lighting Requirements
- Article: How Much Solar Power Do I Need For My RV?
- Article: What are the Common Types of Propane Fittings Used on RVs?


