Installation of Husky Liners # HL57091 Mud Guards on 2007 Dodge Dakota
Updated 03/24/2014 | Published 03/20/2014
Question:
How big of hole will I have to drill? Where do I drill at? Will I have to take the wheel off to get a regular drill in there?
asked by: Elliott
0
Expert Reply:
According to the installation instructions, you will need to drill four holes per mud guard, using a 1/8 inch drill bit. If you do not have a right angle drill, you will most likely need to remove the rear wheels in order to get your drill into position. According to Husky Liners, the # HL57091 mud guards are a fit for 2005-2011 Dakota pick-ups that are NOT equipped with the factory fender flares.
expert reply by:
Mike L
0
Product Page this Question was Asked From
Husky Liners Custom Molded Mud Flaps - Rear Pair
- Mud Flaps
- Custom Fit
- Rear Pair
- Single
- Wheel Well Mount
- Custom Width
- Plastic
- Husky Liners
more information >
Continue Researching
- Q&A: Replacement Lug Nuts for R-Pod Trailer
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Best Suspension Upgrade for 33" Tandem Axles: Road Armor vs Dexter EZ Flex for Ember 22ETS
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Comparing the Curt Hitch C13416 and EcoHitch Hitch 306-X7396 for a 2019 Toyota RAV4
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Recommended SnapPad Jack Pads for a HWH Leveling System on a Motorhome
- Q&A: Recommended Bike Rack and Dual Hitch Adapter for Carrying E-Bikes While Flat Towing
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Measure Your Trailer Wheel Bolt Pattern