How Far From The Edge Of The Door Should The Cutout Hole Be A Bauer Products Entry Door Lock
Updated 08/15/2023 | Published 08/14/2023 >
Question:
What it the backset dimension for this door lock? The required measurement from the edge of the door to the edge of the cutout?
asked by: Kevin
Expert Reply:
From the cutout hole to the edge of the door will need to be approximately 1-1/4" in order for the plunger of the Bauer Products Camper Door Lock # BA44FR to sit far enough out to catch the opening/strike plate in the door frame and hold the door closed. RV doors will typically have a flange that sticks out further than the door itself so make sure you're measuring from the edge of the door and not the flange, otherwise you'll put the cutout hole too far over.
Product Page this Question was Asked From
Bauer Products Camper Door Lock - Polished Chrome
- RV Door Locks
- Entry Door
- Locking Latches
- Keyed Alike
- Slam Latch
- 2-3/4W x 3-3/4T Inch
- Silver
- Bauer Products
more information >
Continue Researching
- Q&A: Replacement Cover/Shroud for Dometic Brisk AC for RV
- Q&A: Replacement Slide Out Motor and Gearbox for Thompson 7828696
- Q&A: Ordering Dexter 3,500 lb Axle with 5 on 5 inch Bolt Pattern
- Q&A: Correct Replacement Arm for Solera V000436372 Awning
- Q&A: Best Replacement Locks For Jayco Jay Flight Rebuild
- Q&A: Recommended Replacement Keys for a Southco Lock on a Horse Trailer
- Q&A: Replacement Horse Trailer Door Lock for 1998 Featherlite
- Article: Glacier Chains
- Article: Flat Towing Package for 2007-2018 JK Jeep Wrangler and Wrangler Unlimited
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Article: Trailer Lighting Requirements
- Article: Trailer Wiring Diagrams
- Article: How Level Should a Tow Bar Be When Flat Towing
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?

