Side Rail Placement When Installing Access LiteRider Tonneau on 2013 Nissan Frontier
Updated 02/20/2014 | Published 02/19/2014
Question:
I have a Access tonneau cover for 2013 Nissan frontier 5ft with a factory bed liner. Do I measure 1/4 inch from the face of the bed liner or the truck bed its self for the clamp on side rails. product code 834532006823
asked by: Bob W
0
Expert Reply:
According to the installation instructions, the clamp-on side rail is mounted so that there is a 1/4 inch gap between the front of the rail and the front of the truck bed itself. If you look at the diagram I provided, it will be a bit more clear for you.
expert reply by:
Mike L
0
click to enlarge
Product Page this Question was Asked From
Access LiteRider Soft, Roll-Up Tonneau Cover
- Tonneau Cover
- Roll-Up - Soft
- Rack Compatible
- Tailgate Lock
- Standard Profile - Inside Bed Rails
- Vinyl
- Matte
- Access
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: What are the Dimensions of the Westin HDX Replacement Rubber Strips
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Parts Needed to Install a Red Arc Brake Controller in a 2023 Toyota Tacoma
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Firestone Air Bags for 2026 Ford F-350 FX4 Dually
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Can Furrion Chill Cube Operate With RV Furnace
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: How Does The Furrion Chill Cube Thermostat Get Wired To The AC System
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box