Removing a Roll Pin to Replace Gears on a Fulton Trailer Jack

Updated 02/19/2014 | Published 02/18/2014

Question:

I need to replace the bevel gear in my Fulton 2500lb jack. I have found your repair kit, and am ready to order, but I have not figured out to remove the roll pin. Can you help?

asked by: Max B

Helpful Expert Reply:

The roll pins used in jacks can be tough to get out because they fit so tightly in place. You will need to use a punch that is smaller than the diameter of the pin and then tap it out using a hammer.

expert reply by: Michael H