bing tracking image
Q & A Icon

Brake Controller Wiring Adapter for a 2023 Greyhawk on Ford E-450 Chassis  


I will be purchasing the brake buddy stealth here in the next week for my 2019 Jeep Cherokee. I have a 2023 Greyhawk on Ford E-450 chassis. What adaptor do I need to connect brake buddy to the chassis wiring? I can’t seem to pull it up. Thank you.


Expert Reply:

To install the Brake Buddy Stealth Supplemental Braking System item # HM39530 in your 2023 Greyhawk you will need the Tekonsha Custom Wiring Adapter for Trailer Brake Controllers item # 3034-S. This connects to the wiring harness behind the dash of your Ford E-450. I have linked a picture of the connector below.

Some other parts you will need to flat tow your 2019 Jeep Cherokee are listed below:

Tow Bar and Safety Chains - Roadmaster Falcon 2 Tow Bar item # RM-520 and item # RM-643

Base Plate Kit - Roadmaster Direct-Connect Base Plate Kit - Removable Arms item # RM-521452-5 base model or item # RM-521451-5 for the Overland and Trailhawk

Wiring Harness - Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit item # RM-15267

Chrage Line - Roadmaster Battery Charge Line Kit for Towed Vehicles item # RM-156-25

High Low Adapter - The tow bar needs to be within 3" of level. If you measure the height of the inside top of the hitch receiver tube on your RV, and the height difference is more than 3 inches above/below the base plate tab height, you'll need a high/low adapter. I have linked a FAQ article that explains all this in more detail along with our selection of adapters.

expert reply by:
Jerred H
Tekonsha Custom Wiring Adapter
Tekonsha Custom Wiring Adapter
(click to enlarge)

Products Referenced in This Question

Product Page this Question was Asked From

Q & A Icon

Continue Researching

See More Q&A Expert Answers >>