Should I Install Drum or Disc Brake Actuator on Old Dump Truck Trailer Conversion
Published 04/18/2023
Products Featured in This Question
Question:
I have a old dump truck that my brother and I cut into a trailer, it has a dually rear axle. My question is will the Demco coupler DM8102232 have enough fluid flow for the drum brakes considering they are not your traditonal trailer brakes? or is there more fluid flow with the disc brake coupler DM8105422 Thanks!
asked by: Adam
Expert Reply:
I would imagine it has to do with the brakes installed on the old dump truck. The Demco Hydraulic Brake Actuator for Drum Brakes # DM8102232 should be producing about 1,200 psi of hydraulic pressure while the Disc Brake Alternative # DM8105422 will be producing a higher 1,600 psi of hydraulic pressure.
If your converted trailer has drum brakes then you'll likely need the drum brake actuator, but if it has disc brakes then the higher rating of the disc brake actuator should be the right option for you.
Product Page this Question was Asked From
Demco Hydraulic Brake Actuator - Drum - Primed - A-Frame - Adjustable Channel Down - 12,500 lbs
- Brake Actuator
- Surge Brake Actuator
- Farm Trailer
- Construction Trailer
- Weld-On
- 12500 lbs GTW
- Channel
- A-Frame Tongue
- Drum Brakes
- No Lockout
- Demco
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Replacement Surge Brake Actuator for 2017 Trailstar Trailer
- Q&A: Trailer Axle With Spring Center To Spring Center Measurement Of 48
- Q&A: Recommended Options for Height Adjustment on 1,800 lb Axle
- Q&A: How To Raise a Square Axle Boat Trailer with Drop Axle
- Q&A: Replacement Hub and Drum Assembly for Lippert 4.4K 136214 Hub and Drum
- Q&A: How to Convert Trailers Air Brakes to Electric Brakes
- Q&A: Bolt Hole Spacing for the Demco Hydraulic Brake Actuator
- Article: Trailer Wiring Diagrams